| |
PILLAR DRILLING MACHINES - P2/25/GT GEAR DRIVE |
|
Specification - All Dimensions are in"mm" |
| Drilling Capacity in Steel |
25 |
|
|
| Morse Taper in Spindle |
MT3 |
|
|
|
| Distance between centre of Spindle & Column Front |
260 |
|
| Max. Distance between Spindle & Table |
590 |
|
| Max. Distance between Spindle & Base |
1080 |
|
| Table Working Surface |
350 |
|
| Base Working Surface |
350 X 300 |
|
|
| Range of Spindle Speeds (rpm) |
100-142-210-310-450/600-852-1260-1860-2700 |
|
|
|
|
| Power of Drive motor |
1HP, 1425rpm, 400/440 Volt, AC, 3Phase 50 Cycles |
|
| Space Occupied [H X B X L] |
1850 X 590 X 820 |
|
|
The Machine will be Supplied with Motor and Rotary Swith
|
|
| Note: |
- The machine also be supplied with the following speeds on customer's request at extra cost.
|
| |
By Fixing 1 HP 960 rpm motor |
65-95-140-205-300 |
| |
|
390-570-840-1230-1800 rpm |
| |
By Fixing 2 HP 720/1440 rpm motor |
50-71-105-155-225-300 / 100-142-210-310-450 |
| |
[Dual Speed Motor] |
426-630-930-1350 / 600-850-1260-1860-2700 |
|
- The Head fixed, up and down movement of the head is not possible.
|
- The machine can be supplied as gang drilling version also with number of drilling heads over a common table. Specification can be furnished on customer's request
|
| |
|
|
Note :
The above specification are approximate only. Due to constant improvement, design and specification are subject to change without notice |
|
